| Dimensions | | |
| Bearing seat | | |
| Da | 72 mm | Diameter of bearing seat |
| G7 | Tolerance class of bearing seat diameter |
| Ca | 34 mm | Width of bearing seat |
| H1 | 50 mm | Centre height of bearing seat |
| | |
| Outside dimensions | | |
| Db | 46.5 mm | Bore diameter |
| A | 83 mm | Overall width |
| A1 | 52 mm | Foot width |
| G1 | 1/8-27 NPSF | Thread of relubrication holes |
| H | 93 mm | Overall height |
| H2 | 22 mm | Foot height |
| L | 185 mm | Overall length |
| J | 150 mm | Distance between attachment bolts |
| N | 20 mm | Length of attachment bolt hole |
| N1 | 15 mm | Width of attachment bolt hole |
| | |
| Seal grooves | | |
| A3 | 59 mm | Inside width between seal grooves |
| A4 | 5 mm | Width of seal groove |
| A5 | 8 mm | Distance to seal groove back face |
| A6 | 11 mm | Width at bore diameter |
| Dc | 54.5 mm | Diameter of seal groove |
| | |
| Dowel pins | | |
| J6 | 172 mm | Distance between dowel pins |
| J7 | 19 mm | Axial offset of dowel pins |
| N4 | max.5 mm | Diameter of dowel pins |
| | |
| Calculation data | | |
| Breaking loads | | |
| P0° | 140 kN | Breaking load at 0° load angle (if the housing is not supported over its entire base) |
| P55° | 190 kN | Breaking load at 55° load angle |
| P90° | 115 kN | Breaking load at 90° load angle |
| P120° | 85 kN | Breaking load at 120° load angle |
| P150° | 80 kN | Breaking load at 150° load angle |
| P180° | 95 kN | Breaking load at 180° load angle |
| Pa | 60 kN | Breaking load, axial |
| | |
| Yield points of cap bolts | | |
| Q120° | 150 kN | Load to reach yield point at 120° load angle |
| Q150° | 85 kN | Load to reach yield point at 150° load angle |
| Q180° | 75 kN | Load to reach yield point at 180° load angle |
| | |
| Materials | | |
| Housing material | Cast iron | |
| Corrosion protection | Paint - in accordance with ISO 12944-2, corrosivity category C2 | |
| | |
| Mounting information | | |
| Recommended diameter of attachment bolts | G | 12 mm |
| Recommended tightening torque for attachment bolts | | 80 N·m |
| Size of cap bolts | | M10x50 |
| Tightening torque for cap bolts | | 50 N·m |
| Initial grease fill, 20% | | 30 g |
| Initial grease fill, 40% | | 50 g |
| | |
| Included products | | |
| Grease fitting | AH 1/8-27 PTF | |
